NC :- Pumping Slurry Across Europe

The NC Super 2 slurry pump is designed primarily as a mixer pump for agitation in an open pit or under slats in a slatted house and is suitable for use with small to medium sized tractors. The pump is not supplied with a top fill kit but this can easily be fitted if required. The pump is supplied complete with a specially designed hydraulically operated lifting frame and ram to control the height of the pump in the tank . This enables the pump to be manouvred to different tank depths from the seat of the tractor without tool adjustment. (no awkward clamp bolts or handles are required). This allows the pump to be moved from tank to tank by one operator without leaving the tractor seat. The mixing spout is designed to be swivelled in a wide arc and most important, when agitating in a slatted house the mixing spout can be directed underneath the tractor.

Super 3 Slurry Pumps

These high - performance pumps have been designed to give increased jetting and filling capacity. This has been achieved by careful design which has eliminated all restrictions from the time the slurry enters the pump until it leaves it.
Compared with the Super 2 the Super 3 slurry pumps are built to a higher specifiction.
Some of the main advantages are:-

  1. Pump can be transported from tank to tank without removing
    PTO shaft.
  2. Heavy duty lifting frame and arms
  3. Double acting ram for easier manouvrability
  4. Mixing spout fully lockeable in 17 positions by locking pin
  5. Can be fitted with electronically operated radio - controlled
    spool valves. This enables the pump to be changed from mixing
    to pumping and back again to mixing without leaving the tractor
    pulling slurry tank.
  6. Due to the design of this pump the same pressure and volume
    of slurry are pumped when either jetting or pumping upwards to
    a top-fill tank or store. This makes the pump invaluable when
    pumping into above ground store.
  7. Two point linkage essential for hitching and unhitching to
    tractor

The Super 3 Slurry Pumps

On the Super 3 slurry pump the lifting arms are designed by simply fitting two additional pins the pump can be lifted to a height of at least 6ft, enabling the pump to be transported horizontally or vertically. This is important when space behind tractor is restricted. It aiso enables the pump to be set over a wall when mixing behind a feeding passage or lifted over cubical rails when negotating tight turns in narrow passages. The Super 3, like the Super 2, has a wide angle mixing spout which can also be deflected underneath the tractor driving pump.

 

Six models are available:

  • The mixer pump
  • The Super 2
  • The Super 3
  • The Super 3 Static
  • The Super 3 static electric
  • The Super Plus

Details

  • Galvanised models on request
  • Slurry pumps can be manufactured to most customers
    specifications
  • Models depth range from 1 .4m - 6m (4ft - 1 9.6ft)
  • Capacity 2000 - 4000 gals (9000 - 18000 Itrs) per minute